10.25" Square Swivel Replacement for Recliner Chair or Furniture - Ball Bearing Swivel Plate Mechanism - Flat - S1235-1

The item worked perfectly and came earlier than expected.

Good productions thick material heavy duty strong

Our swivel recliner bit the dust. After 10+ years of abuse by kids and supporting large adults, it's been showing lots of wear. For about a year it's been swiveling too freely. And yesterday, there was a pop and ball bearings rolled onto the ground.I flipped the chair over and removed the four bolts holding the previous square swivel to the chair and the four bolts holding that to the base. The problem with the original square swivel was pretty obvious. The bolt holding it together had pulled the nut and (too big) washer through the hole. I thought it MIGHT be possible to replace just the bolt and washer, but the hole was messed up too and I saw this square swivel was fairly affordable on Amazon and was even available Same Day Prime for me. So I ordered it.It came later in the day, and was quick and easy to install. The eight bolts took less than 5 minutes to reinstall. Like other reviewers have observed, this appears to be a higher quality square swivel than the one that the manufacturer used. It feels very solid and the bolt assembly and the hole it goes through looks like it'll hold up much longer.I'd MUCH rather spend a little bit of money (and a few minutes of labor) repairing my favorite recliner than try to find a new one.

good replacement for my recliner, too soon to tell if it will hold up. original one was weak and deformed which made chair difficult to use

Bought a used recliner, but when my friend lifted the base off my cargo carrier, all the ball bearings fell out of the original swivel part. Tried to put them back in, but the bolt was welded to the nut, so I was unable to do it. This product made the recliner balanced and it swivels beautifully now! Sure beats buying a new recliner! When this recliner wears out (overuse, weather, cat, etc.), I'll be saving this piece for the next used chair I buy.

I used this to make my 72 inch cut Ferris Lawn Mower have a swivel seat. I only have a left leg and I did this so I could more easily use a weed eater while I move about on the machine. This allows me to more easily trim from the mower. I had to match and drill for the already female receiver nuts in the seat and then also drill new holes for the mounting to the frame. This done, the swivel has proved to be of high quality and very sturdy. It is well made and would fulfill any requirement where it can be mounted. The bearing is heavy duty and would handle any reasonable weight, probably up to 500 pounds.

We were given a used, but very nice, swivel rocker/recliner a few years ago. However, over time, the chair got so it would spin so actually could have become dangerous if it were spinning as one attempting to sit down. A previous reviewer said he replaced the plate in 5 minutes. It actually took my husband quite a bit more time than that but still not a difficult job. The chair is now just fine and like new again. The $40 investment in the replacement plate was money well spent since replacing the chair would have cost at least $300.

I used this to replace a swivel rocker chairs worn out swivel. I have had it in place for over a month and it works great. Was easy to install and seems to be as good as the original. Saved me a lot of money as compared to having the chair repaired or purchasing a new chair. I would highly recommend it at this time, but the true test will be the longevity of the repair.