10PCS Wood Cutting Saw Blade Oscillating Kit Multi Tool for Dremel Fein Multimaster Makita Bosch Mix Multitool Blades Set

Brought these because they were listed as Amazon choice, sadly they are not very good quality, would be ok for cutting out plaster board. I did two vertical cuts in a 6inch softwood skirting board and the blade just burnt out before I had finished the second cut. Put in the Branded blade that came with my Dewalt multitool and it was vastly better, didnt even get warm. would i buy again? no, sorry

as a frequent user of these tools I though I try a value range product as I use so many of them. However I soon learnt the you "gets what you pay for". In the process of laying a 7mm laminated floor in a small room I went through 4 of these blades, normally I would use not even one to its fullest. They did the job and at £10 I wouldn't say I wouldn't buy again but don't expect long use out o tech blade.

I purchased these saws to cut wooden floor tiles it did not go will the saw performed will but lost it sharpness very quickly. but in all honestly I give it a job that high tensile circular saw hard trouble with. for the price under normal circumstances it would have done the job.

I go through a lot of these blades in my profession as a bathroom fitter and plumber and I can honestly say that the batch that I received is every bit as good as the more expensive ones sold in diy stores and at a fraction of the cost.

I bought these blades because I had some floorboards that needed lifting so I could lay some central heating pipes. They cut well but the blades blunt quickly, also one of the blades snapped at the spot welds. Would I recommend these blades to a DIYer, yes. Would I recommend them to someone in the trades, well you get what you pay for........

I originally bought 10 of these blades which were absolutely fine and lasted well considering the price so i just bought another 20 for this job im on . Absolutely nothing like the 1st batch . One cut and the edge is gone and i mean virtually smooth .Not nearly the same quality and very disappointing.In future i will buy a different brand .

Seem very good quality, only used one Blade so far cutting up an old sofa, coped well going thru the wood frame which also had many small nails and staples but the Blade coped fine

For the price they're fine. I generally use them on plaster board and they do a decent job. They do blunt fairly quickly on wood, so I'd spend a little more for better quality if that's what you're looking to use them on.For me though, they're more than adequate, I'll be buying again.